Measure dryer inlet pressure where the dryer will actually sit

Pressure shows up in dryer sizing twice: in the flow figure (stated at some pressure) and as a correction factor (capacity changes with inlet pressure). Both need the pressure at the dryer inlet, whic

Pressure shows up in dryer sizing twice: in the flow figure (stated at some pressure) and as a correction factor (capacity changes with inlet pressure). Both need the pressure at the dryer inlet, which is often not the number people quote.

Common substitutes, and why they mislead:

  • Compressor cut-out pressure. This is the peak. The dryer spends much of its time below it.
  • Tank gauge. Fine if the dryer is right next to the tank. Not fine if there’s a long run, a filter, or a regulator in between.
  • Tool pressure. The regulated pressure at the tool is downstream and lower.

For sizing, record the pressure at the proposed dryer location during normal operation, and note the range between cut-in and cut-out. Lower inlet pressure generally needs more nominal dryer capacity to treat the same flow, so using the peak number can undersize the unit.

Also ask the supplier for the pressure drop across the dryer at your flow. It reduces what reaches the tools, and it varies by model.

Write it down as “inlet pressure: ___ psig, measured at ___, during ___.” That one line saves a round of back-and-forth with every supplier.

The AirDryerSizing worksheet has a dedicated field for dryer inlet pressure next to delivered flow.

Write a comment